How To Start A Level Vinyl Siding Starter Strip

The starter strip is the first strip of vinyl siding that is nailed to the wall.

How to start a level vinyl siding starter strip. The bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Find vinyl siding starter strips at lowe s today. 1 2 inch 1 3 cm plywood or osb are common substrates and these are generally covered with roofing felt or another moisture barrier prior to siding the walls.

Below the top of the foundation but the lower the vinyl siding is installed the better. Vinyl siding starter strips. Remove any siding or exterior finish that isn t compatible with vinyl siding and make sure the walls are sheathed with a substrate to receive the siding. Remember to make sure the sheathing is smooth before you apply the siding so the siding can be smooth also.

This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. It is a small strip of vinyl siding that has a locking channel on it that the first full sized vinyl siding panel. Staret strip secures the first course of siding to the home. This video shows how to install a starter strip for vinyl and polymer siding installation.