How To Replace Drip Edge On Flat Roof

Let s face it many homeowners may not be aware of what a roof drip edge actually is or what it does for a roof and if they are aware they may be talked out of installing it because of cost factors involved with roof replacement or repairs.

How to replace drip edge on flat roof. It bends around the edge of the roof channeling any moisture that penetrates the shingles away from the roof decking. 12 roof repair tips. How to install a drip edge. Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.

Use a flat pry bar and hammer to pry the nails out. This lets any water that gets on the roof run down the underlayment and over the drip edge. I have an arizona white reflective flat roof. Make sure the outer edge extends over the gutter.

The problem is that a drip edge is technically supposed to be part of any shingle roof manufacturer s installation instructions and the process is. Lift the shingles slide the drip edge underneath them and position it so that it extends over the gutters then replace the shingles and push down to seat the drip edge. Secure the drip edge with roofing cement. The best way is to install the roof drip edge only along the eaves first then place ice and water barrier in the snowbelt or felt paper underlayment over the drip edge.

If it doesn t pull the drip edge out slightly from under the shingles. Metal drip edge flashing is an important element of any roofing edge. Use a flat pry bar to remove drip edge nails along the eave and rakes. You may need to use a putty knife to break the seam between the first course and the starter strip.

Some years ago i installed flashing under the drip edge and into the back of the gutter to keep water off of the fascia board. The drip edges and gutters are on the back of the home on the patio side. Find and fix a leaking roof. Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto the roof.

It can be done. Coat the flat part of the flashing that sits on the deck using a putty knife.